ICC IC107PPS6A Manuel télécharger pdf

888-ASK-4ICC [email protected] icc.com

INSTALLATION INSTRUCTIONS

Blank Patch Panel for Category 6A FTP 10G, 24-Port, 1 RMS

Step 1: Mount the patch panel to the rack using four (4) #12-24 rack

screws.

Step 2: Install the cable management bar onto the rear of the patch

panel. Align the tabs on both sides and push the bracket downward until

fully seated. Use the grounding screw (included) to attach grounding wire

(not included).

Step 3: Insert the CAT 6A FTP modular connector into a port on the patch

panel. Note: Inspect the connector to ensure it is fully seated, and the

front is ush with the panel.

Step 4: Secure the cable to the cable management bar using a nylon

cable tie. Note: A slot on the bar allows you to insert and secure the tie.

Rack

Slot

Grounding screw

Cable tie

1 2

Pas de commentaire

ICC IC107PPS6A Manuel